LINQ 2m Rope Kermantle
2m Rope Kernmantle c/w RG13D with Perm KTASA26 Ers Cover & Snap Hook to Thimble
Related products
-
AccessoriesSKYLOTEC Suspension Relief Straps
SUSPENSION RELIEF STRAPS should be ordered with each harness without further thinking: they serve to alleviate the potentially lethal [suspension trauma](http://en.wikipedia.org/wiki/Suspension_trauma) from a fall and therefore could save your life, since applying these loops give you a substantial amount of precious minutes extra-time before a rescue arrives! On top of that, these SUSPENSION RELIEF STRAPS have no expiration period and can be reused. Take them with you each and every time you use your harness. Better safe than sorry!
(0 reviews) -
AccessoriesGRIPPS Kevlar Cable Retractor Unit with Auto-Stop
The GRIPPS® Kevlar Cable Retractor Unit with Auto-Stop presents an optimal compact solution for tethering small tools weighing up to 0.5kg / 1.1lb.
With smooth and precise extension capabilities of up to 1.2m / 47in, these retractors guarantee tools are consistently within reach.
The Kevlar’s locking mechanism secures the cable at length during tool operation, enhancing ease and efficiency.
(0 reviews) -
Pole StrapsLINQ Pole Strap with Snap Hook
- Snap hook at each end
- Custom lengths available
(0 reviews)Add to Quote This product has multiple variants. The options may be chosen on the product page -
Tool ConnectorsGRIPPS Tool Catch (Non-Conductive)
Tool Catch (Non-Conductive) – 12mm x 55mm (10 Pack)
The GRIPPS® Non-Conductive Tool Catch offers a sturdy, dependable, and long-lasting retrofit certified, load-rated, and non-conductive tool connection point when used with GRIPPS® V-Gripp Tape, suitable for a live electrical environment.
The GRIPPS® Non-Conductive Tool Catch is designed to provide a retrofit tool connection point suitable for a live electrical environment.
Secure the GRIPPS® Non-Conductive Tool Catch onto your tool using GRIPPS® V-Gripp Tape to establish a certified, load-rated, non-conductive tool connection suitable for a range of hand tools.
Installation Instructions
- Cut a length of GRIPPS® V-Gripp Tape approximately 30cm/12″ (or enough to go around the tool 10 times).
- Position the GRIPPS® Tool Catch on the tool.
- Apply GRIPPS® V-Gripp Tape , pulling it tight and without covering the “ring” on the GRIPPS® Tool Catch.
(0 reviews)